Setting up SimplyPrint on Monoprice MP Mini Delta: Creality Nebula Smart Kit method

Creality Nebula Smart Kit setup for this printer. Follow the steps to connect your Monoprice MP Mini Delta 3D printer to SimplyPrint.

Monoprice MP Mini Delta image
Back to MP Mini Delta
  • 1 Readying Nebula Smart Kit
  • 2 Set up

Set up SimplyPrint for Moonraker via CLI

To set up SimplyPrint for Moonraker without going through a UI like Mainsail or Fluidd, you've got to edit the Moonraker configuration file and add the [simplyprint] component.

The SimplyPrint component comes pre-installed with all newer versions of Moonraker, so you simply have to add the component to the config file like this:

  1. SSH into your Pi (or whichever device is running Moonraker) You can also simply connect a monitor and a keyboard to the device and interact with it directly.
  2. Update Moonraker First go to the Moonraker directory - often located in your user's home directory, so after logging in simply execute the following commands:
cd ~/moonraker
git pull
./scripts/install-moonraker.sh
  1. Go to the moonraker.conf file The Moonraker config file is usually located at ~/klipper_config/moonraker.conf
  2. Add [simplyprint] to the bottom of the file
  3. Save and restart Moonraker:
sudo service moonraker restart

That's it! You're all set

You're now ready to connect your printer and start using SimplyPrint.

Create your free account
Back