Setting up SimplyPrint on Anycubic Kobra 3 V2

Easy steps to connect your Anycubic Kobra 3 V2 3D printer to SimplyPrint.

Anycubic Kobra 3 V2 image
Back to printer compatibility page
Back to Anycubic

Choose how to set up your Anycubic Kobra 3 V2

This printer works two ways. Pick whichever suits you - you can switch later.

SimplyPrint Anycubic
SimplyPrint Client
Recommended

One small app on a device on your network bridges this printer to SimplyPrint. More features, and nothing is changed on the printer.

  • Full Anycubic ACE multi-material support
  • No firmware changes on the printer
  • One device connects many printers, across brands
  • Needs an always-on device on your network
Get the client
Set up on the printer
No extra device

Connect directly through the printer's own firmware (Klipper / OctoPrint). Best if you would rather not run a separate device.

  • No separate device to run
  • Connects straight from the printer's firmware
  • No Anycubic ACE multi-material support this way
  • Fewer smart features, and one setup per printer
Set up on the printer