Skip to main content

Setting up SimplyPrint on Anycubic Kobra 3 Max V2 Combo

Easy steps to connect your Anycubic Kobra 3 Max V2 Combo 3D printer to SimplyPrint.

Anycubic Kobra 3 Max V2 Combo image
Back to Anycubic

Choose how to set up your Anycubic Kobra 3 Max V2 Combo

This printer works two ways. Pick whichever suits you - you can switch later.

SimplyPrint Anycubic
SimplyPrint Client
Recommended

One small app on a device on your network bridges this printer to SimplyPrint. More features, and nothing is changed on the printer.

  • Full Anycubic ACE multi-material support
  • No firmware changes on the printer
  • One device connects many printers, across brands
  • Needs an always-on device on your network
Get the client
Set up on the printer
No extra device

Connect directly through the printer's own Klipper firmware, over Moonraker. Best if you would rather not run a separate device.

  • No separate device to run
  • Connects straight from the printer's firmware
  • No Anycubic ACE multi-material support this way
  • Fewer smart features, and one setup per printer
Set up on the printer