Setting up SimplyPrint on MakerBot Replicator+: Creality Sonic Pad method

Creality Sonic Pad setup for this printer. Follow the steps to connect your MakerBot Replicator+ 3D printer to SimplyPrint.

MakerBot Replicator+ image
Back to Replicator+
  • 1 Readying Sonic Pad
  • 2 Fluidd setup

Add [simplyprint] to the moonraker.conf config file

  1. Go to the "Configuration" tab
  2. Under "Configuration Files", click on the moonraker.conf file
  • NOTE: if you have a custom moonraker config file, or one called moonraker.generated.config, you may need to edit that file instead
  1. Add [simplyprint] to the bottom of the file (with an empty line above it)
  2. Click the "Save & restart" button
moonraker.conf config file Edit moonraker.conf

Lastly; link your printer to SimplyPrint

After saving and restarting, your printer should appear automatically in SimplyPrint!

  1. Go to SimplyPrint.io and click Add Printer
  2. Check Pending Printers - your printer will likely appear there automatically
  3. Click to add it and you're done!

If your printer doesn't appear in Pending Printers:

This can happen if you're not on the same network as your printer (different outgoing IP). In this case, use the setup code:

  1. In the "Announcements" bell (🔔) in the top bar, find the "SimplyPrint Setup Request" message
SimplyPrint setup code
  1. Copy the setup code and paste it in SimplyPrint under Add Printer

Still having trouble? See our guide: Printer in setup isn't detected / can't find setup code.

Need help?
Claude Ask Claude ChatGPT Ask ChatGPT Perplexity Ask Perplexity Grok Ask Grok

Thousands complete this setup every week. Follow each step carefully - most issues come from skipping ahead.

Why some setups are tricky: Some manufacturers lock down their printers, requiring workarounds like custom firmware. If hardware is listed as required, there's no shortcut.

About support: Direct setup support is available for Enterprise & School plans. Our AI support bot can help everyone else just as effectively.

Community help: Join our Discord for community support and tips from other users.

Markdown version of this guide - paste into any AI assistant

That's it! You're all set

You're now ready to connect your printer and start using SimplyPrint.

Create your free account
Back