Setting up SimplyPrint on Anycubic Chiron: BIGTREETECH Pad method

BIGTREETECH Pad setup for this printer. Follow the steps to connect your Anycubic Chiron 3D printer to SimplyPrint.

Anycubic Chiron image
Back to Chiron
  • 1 Readying BIGTREETECH Pad
  • 2 Fluidd setup

Set up SimplyPrint on the BIGTREETECH Pad

In this quick guide you'll find the BIGTREETECH Pad's IP address and then proceed directly to Fluidd to finish the SimplyPrint setup.

In this guide we will go through:

  1. Find your BIGTREETECH Pad's IP address
  2. Open the Fluidd web interface

1. Find your BIGTREETECH Pad's IP address

  1. On the Pad touchscreen, go to "More" → "Network".
BTT Pad homescreen BTT Pad settings - Network
  1. Connect the BIGTREETECH Pad to your Wi‑Fi or wired network, if it isn't already.
  2. Once connected, note the IP address shown on the Network page (top‑right). For example 192.168.1.42.
BTT Pad network screen showing IP

2. Open the Fluidd web interface

In your browser on your computer or phone, visit http://[IP_ADDRESS] (replace with the IP you just noted).

This opens the Fluidd web interface hosted by your BIGTREETECH Pad.

Now, proceed to the next step, which will guide you through enabling SimplyPrint in Fluidd by adding the required [simplyprint] section to your moonraker.conf file.

That's it! You're all set

You're now ready to connect your printer and start using SimplyPrint.

Create your free account
Back Next