Setting up SimplyPrint on RailCore Labs / Project R3D RailCore II 300ZL/300ZLT: BIGTREETECH Pad method

BIGTREETECH Pad setup for this printer. Follow the steps to connect your RailCore Labs / Project R3D RailCore II 300ZL/300ZLT 3D printer to SimplyPrint.

RailCore Labs / Project R3D RailCore II 300ZL/300ZLT image
Back to RailCore II 300ZL/300ZLT
  • 1 Readying BIGTREETECH Pad
  • 2 Fluidd setup

Add [simplyprint] to the moonraker.conf config file

  1. Go to the "Configuration" tab
  2. Under "Configuration Files", click on the moonraker.conf file
  • NOTE: if you have a custom moonraker config file, or one called moonraker.generated.config, you may need to edit that file instead
  1. Add [simplyprint] to the bottom of the file
  2. Click the "Save & restart" button
moonraker.conf config file Edit moonraker.conf

Lastly; get the SimplyPrint setup code

In the "Announcements" bell in the top bar, find the "SimplyPrint Setup Request" message, copy the setup code and proceed to the next step!

SimplyPrint setup code

If you do not see the "SimplyPrint Setup Request" message, you may see the printer inside SimplyPrint already under "Add printer > Pending printers". Otherwise, please refer to this guide for more information: Printer in setup isn't detected / can't find setup code.

That's it! You're all set

You're now ready to connect your printer and start using SimplyPrint.

Create your free account
Back